About ElikCyber

ElikCyber · 10-22-2011

Hello, I have been reading up on the VACL and ACL but I am little confused on how to properly implement it. Basically, I have a VLAN setup with 10.1.100.0/18 which I am using to setup the Local LAN network, but I do not want it to be accessible or ...

ElikCyber · 10-15-2011

Hello folks, I figures i post on here to pick on your brains to see if there is a solution to the problem I am having. Basically, I have setup the PXE server that is located on 3650G Switch, and it is under VLAN10 which is on the private LAN netwo...

ElikCyber · 07-05-2018

Here is the running config, with senstive IP information blotted out:I also included the show ip route for the gateway to show the issue:

ElikCyber · 10-15-2011

Hello, Thanks. With that comment, plus few others, I am able to get it working properly now. I had to add few lines to the ports on the 3650G to have it reduced down to 10 secs for DHCP bootup with this configuration:interface FastEthernet0/22 swi...

ElikCyber · 10-15-2011

Hello, It is not blocked as far the DHCP is concerned, or even across the VLANs itself. Just when the server is booted up, it have 20 seconds to get the DHCP response, to connect and fetch the boot file. However, it seems that from what I can tell...

Member Since	‎10-15-2011 08:17 AM
Date Last Visited	‎08-15-2018 02:19 AM
Posts	6

User Statistics

User Activity

Proper way to Block Traffic between Lans - VACL & ACL

PXE with DHCP Issues - 7600 Router to 3650 Switches with VLANs

Re: Cisco 4900M Vlans not turning up

Re: PXE with DHCP Issues - 7600 Router to 3650 Switches with VLA

PXE with DHCP Issues - 7600 Router to 3650 Switches with VLANs