Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im not sure whats going on here ... checked the obvious. Shut, ip space, duplex/speed matc, ip routing isnt on Reviewing the Config guide for the switch ... Im stumped .... 3550_1#show ip int brInterface IP-Address OK? Method ...
If I have an office with a single switch, with workstations wired correctly ...No layer 3 at all only a layer 2 switch ... (ofcourse no remote management either) What protocol is used by the switch and workstations to exchange mac info. Im thinking t...
I need to touch a few hundred switches and would like to automate show module necessary to support the os config push listed in the How to section. Can anyone tell me how to do it ?
I have already opened a tac case. I need to touch over 10k devices using snmp to set an initial config. I have snmp scripts but want to be sure I do the push with the nondepreciated oid per IOS/OS. Does anyone know of or have a matrix of IOS/OS oid/m...
Does anyone know of a perl module that can obtain the actual model type of a cisco device Not this :Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(16), RELEASE SOFTWARE (fc1) ...
I have fa0/1 and fa0/2 configured as an access port. fa01 is connected to the 2610 router.fa0/1 is connect to laptop. Debug cdp packets shows cdp v2 packets out for fa 1 and 2 on switch. Debug cdp packets shows cdp v2 packets out for fa 0/0Neither in...
well i originally configured the 3550 fa0/1int fa0/1switchport mode accessswitchport port-securityswitchport port security mac-address wanted to see port security working ... Once cdp wasnt up, I then configured portfast .. but no change. just tried...
Timers match ..Show cdp traffic shows advertisements out both devices r1 is the 2610xm3550_1#sh cdp int fa0/1FastEthernet0/1 is up, line protocol is up Encapsulation ARPA Sending CDP packets every 60 seconds Holdtime is 180 seconds3550_1#R1#show ...
As you can see in my original post, The link between the 2610 that the 3550 is connect to is up/up across 3550 fa0/1 -> 2610 fa0/0But I am unable to see cdp info. Although on by default, I when ahead and enable it globally on both devices. Vlan 1 is ...
