Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I wonder when i try to ping wireless client from my pc and from layer2 switch, it's not work, but when i use layer3 switch ping to client, it's work. This is my networkmy pc--layer3sw --layer2sw --AP --clientI can see mac-address of client on layer3s...
Q1. what's different between LLQ and CBWFQ ? because i think CBWFQ can classify packets and guarantee bandwidth for each class (not necessary to use strict priority queue) Q2.If strict-priority queue have packets then non-priority can't transmit pac...
Histatic mac-address x.x.x.x vlan xx interface f0/0 interface f0/1 if this packet come to switch, switch will send out two interface or load-share on each interfaceThanks
Hi RickMy Linux server is NTP master and sync time from Internet. Cat6509 will sync clock with Linux server and then all access-layer switch will sync the clock with Cat6509Thanks for all reply
Thanks for replyIn this issue, I have two switch connect to the two firewall. Because the firewall is gateway and load-balancing (Cluster)then i setup virtual ip address and virtual mac-address. Two switch connect each other with trunk port and i con...
Thanks all reply for share knowledgeI'm not sure my idea is correct or not, please suggest me if it's wrong.Switch port that configured portfast mode still in STP process, it can change state from forwarding to blocking , if i enble portfast the bpdu...
