Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi GuysI have upgraded my VC to 5.1 and am using nexus 4.2(1)SV1(5.1a)When i go to register the plug in i get the message below , all hosts are 4.1.0 specified parameter was not correct, extension.keyCall "ExtensionManager.RegisterExtension" for obj...
Hi everyoneIm new to the nexus 1000v and i had a questionLets say you have 6 nics and 3 different uplink profilesLAN - vmnic0 +1MGT - vmnic 2+3Vmotion - vmnic 4+5I understand how to ensure vmotion will use nic 4+5 etc - create vmotion vmkernal and...
hi guysi have HP bl 620G7 with 1000v and vsphere 4.1. . when a physical upstream switch port goes down , my cisco 1000v doesnt notice that its down and when we bring back up the upstream port the vsm port attached to the physical nic does not come u...
hi guysi have a nexus 1000v where i have two nics on a vm. i can ping hosts on same portgroup and same host no probs so its not esx issue.when i disable nic 0 and ping GW using nic 1 then its ok, when i enable nic0 / disable nic 1 and ping GW then it...
hellothe vsm was connected to the old vcenter , which isnt running anymorewhat is the correct procedure to unregister the vsm if it is still connected to the old vc ?
MatthewI thought that you only used system vlans for uplink port profiles!If you didnt add the sytem vlan to this config then what would the outcome be ?port-profile type vethernet vmotionvmware port-groupswitchport mode accessswitchport access vlan ...
MatthewThanks for the reply.So is it a very bad configuration so to have just one uplink port profile and all nics assigned to it with the uplinks trunking all vlans ? Would you see packet loss in that situationWIth regard to your config above , is i...
