Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All we have two fireawalls configured in active/active mode with two context.All the interface of two contexts are shared.How can i change the mode of failover from active/active to active/standby with minimum disruptionThanks in advance
Dear All For our client, we have two ACS 5.0 deployed in primary and secondary mode.Primary ACS is failed and we are going to replace the hardware.Problem is we dont have backup of primary ACS and have backup of only secondary ACS.Also there is ce...
Hi All We have ISE 1.0(4) running on vm ware with base license.We have two normal controller and one anchor controller also.We have to integrate WLC with ISE so that for guest users,ISE will act as the guest portal.Please send me the configuration...
Hi all I have configured ASA firewall for command authorization with ACS.For users with privilege level 15 it is working fine.But when i login with users with privilege level 0, first when i enter the username and password ,it enters into enable mo...
Thank you Andrew for the response.In our case,we have two context named A1 and A2.A1 is active on ASA-1 and A2 is active on ASA-2.What we require is to transfer all traffic for A2 to A1(this can be done by changing the routing on upper and down layer...
Hi Noel Thank you very much for the information.Colud you please tell what is the configuration on WLC and ISE for Guest portal (redirection from ISE).Thanks in advanceAnvar
Dan Thanks very much Dan.Actually aaa requests were going to ACS2 .and I configured authorization sets on ACS1.After replication its workink fine.Thanks very much for your supportRegardsAnvar
