Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello i have nexus 7k that i have a policy based routing setup as follows for 2 vlans, 802 and 803, to set default route out to a host in vlan 802. i have applied my policy to the vlans and everything works fine for a host in vlan 803, it routes over...
Hello i have a few Linksys WET200 wireless bridges i am looking to implement on my campus with Wism controllers and a mix of 1130 and 1000 Lwapp APs. I have been able to configure them to work with WPA-Tkip PSK however as soon as i try wpa2-aes PSK t...
Hello i have spent the greater part of the day trying to get my Clean access manager to Authenicate against my Windows IAS server. I can see the connections showing up in the logs however i keep getting registration rejected or no matching policy err...
Hello i recently installed a 4404 controller and puchased some 1130 LWAPP aps. Today i am brinign trying bring up a 1130 ap on that new controller. The ap is registering to it however the Radios will not come up and i am getting this text on the AP's...
Thanks Jon ,I could see this being the case when destination is 172.21.1.237, however this is routing to internet so default gateway is used, hits pbr, then seems to vanish....I would think it would hit pbr then send back to 172.21.1.237...like any o...
I to am experiencing the same thing, however, most of mine seem to be tripping when the other side is Google which i find odd....I am trying to figure out what the end users are doing to cause the signature to fire but so far have not been able to re...
Im experienceing the same speeds however im also having cases where the clients will not pass traffic. They dont get disconnected. They just will not pass traffic for a minute or so and then pick up again. Has anyone else experienced this with the In...
Where you ever able to resolve this. i am running into the same issue currently. I get spotty dhcp responces to my WLC controllers.Any help is appreciated. scott
