Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I installed a new VM for Cisco MSE 7.6.132 yesterday. I was able to access it through SSH. However, when I came in today morning. I can still ping the machine but can't SSH. I have checked "service sshd status" with result "openssh-daemon (pid...
Hi,
Can you share the running configuration for trunk ports on both switches and "show interface trunk".
Cant you use a normal cable with all pairs?
-Jay
Hi Raj,
You can run the VSS switch without its pair indefinitely. You can look under "Failed Chassis Recover" under the document I mentioned in the first post. It advises the same thing.
Make sure that the switch priority is configured correctly an...
Hi Aerone,
The NME-16ES-1G is a layer 2 switch module. The only way you can make it work in your situation is by thinking of it as a layer 2 switch and configure it as "router on a stick" configuration. You can create SVIs on the router, create a tr...
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-4000-series-switches/65591-cat4500-high-cpu.html
According to the above document, do a show platform health. This will tell you what each process is taking up. Mgmt LoPri is actually an aggr...
Hi Raj,
You can most certainly do that. Refer to the document here (under Converting the Chassis to Virtual Switch Mode)
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/vss.html#wp1055998
In my opin...
