Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Earlier this week I followed the Cisco instructions below to convert C9105AXI-B to Embedded Wireless Controller (EWC) as well as the YouTube VideoConvert Catalyst 9100 Access Points to Embedded Wireless Controller - CiscoConvert Catalyst 9100 Access ...
I ran into an issue where I purchased two C9105AXI-B units without realizing they require a controller. For my application I am looking to have two C9105AXI-B connect with each other and no other devices. I found the following article that explains ...
Hi,I am trying to confirm which roll over cable will interface with the Cisco C1300-8P-E-2G network switch? I am looking for USB-A on one end and RJ45 on the other to the C1300. I am having trouble finding information regarding these cables on the ...
@aleabrahao If you have time, I would appreciate recommendations for setting up the C9105.Last Thursday I tried the following but the admin password I entered didn't work. Tomorrow, I am going to try a factory reset (hold the button for 20 seconds) ...
@aleabrahao Thanks for the clarification, that would explain the "Host IP address : 10.225.170.17" displayed during C9105 during boot. That must be the controller IP address.Normally should the AP register with the controller or does it need to typi...
@Mark Elsen Below is the output for the following commands. The # wireless config validate command shows that the default country is not specified but the configuration shows the country code is specified. Is there a way to set the default country ...
@aleabrahao Below is the output from the three commands. The last two were shorted because just the headers were displayed and the text was preventing me from replying. EWC>show ip interface briefInterface IP-Address OK? Method Status ProtocolGigabi...
@aleabrahao I think you are correct. Do you know of a way to remove the EWC image or re-install an EWC image? I don't recall the following command working but I holding the button for 20 seconds on power cycle does reset the EWC settings to day 0.I...
