Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am struck up with changing the country code using GUI & Cli cmds and Configuring the SSID with WPA security mode on Autonomous AP with (ap3g2-k9w7-tar.153-3.JBB1.tar)
I have one CISCO-3700i access point (AIR-CAP3702i-D-K9) I have done conver...
Hello all, Recent past I had purchased one CISCO( AIR-CAP3702I-D-K9 ) AP. yes I understand that default it is a controller based AP. I wanted to convert it into Autonomous AP. can anybody help me ? 1. What is the software(IOS) version is need for pa...
Hi, I wanted to create one SSID using cli commands, on AIR-AP1230B-A-K9.Please find the attached my ap details in "ap info.png", To create the ssid(in open authentication mode ) using cli commands i had followed the below steps. AP1200(config-ssid)#d...
Hi,I wanted to setup my Aironet AIR-AP1230B-A-K9 model ap with multiple SSIDS,I had followed the steps mentioned in below link,http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-4_10b_JA/configuration/guide/scg12410b/scg12410b-chap7-mbssid...
Hello Sandeep,
Thanks a lot for your response. but i wanted to cahnge the counrty code also for my configurations of wifi network.
I had followed your steps and commands to configure the wpa network. observed below error on console.
AP3700(config-...
Hello Prakash,
Thanks for the response that you provided to me on my problem.
the correct and exact solution is for my particular model i.e 3702i model follow below link. it worked fine.
http://www.chainringcircus.org/cisco-3702-lightweight-to-auton...
Hello Venkatesh,I had followed the steps which you mentioned and downloaded ios/image(ap3g2-k9w7-tar.153-3.JBB1) as mentioned in your previous post.Please find the attached console log, I have few queries .1. In your post stated that after finishing ...
Hi, I wanted to create one SSID using cli commands, on AIR-AP1230B-A-K9.Please find the attached my ap details in "ap info.png", To create the ssid(in open authentication mode ) using cli commands i had followed the below steps.AP1200(config-ssid)#do...
