Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I'm currently trying to setup static NAT's in my home-lab to do port-forwarding using my public IP. I've done this previously with the my router without any issues, but I'm currently unable to get this running on my ASA5505. Currently my P...
Hi All, I'm currently trying to establish a GRE tunnel between end Routers via Internet (Home lab) I first want to establish a GRE before moving on to IPSec. Problem I currently have is my ZBF do notallow the GRE to establish. (Configs attached) Any...
Good-day All,
I am just working on my home lab currently and tried to implement a Etherchannel on a router-on-a-stick topology. My hardware is an old 3560-8port switch and 887VAG Router. What I would like to accomplish is to have a 200Mbps uplink fr...
Hi All,
Thanks for the great forum !!
I'm currently in a small size ISP and is studying MPLS and the implementation thereof. Apologies if I ask a simple questions, but I want to be able to understand the concepts/implementation of MPLS in the ISP inf...
Hi Marius,
After hours of troubleshooting I finally got in touch with my ISP, which confirmed the rolled out new Firewall rules in their infrastructure. I requested my Public IP be white-listed and I can successfully browse to my servers via domai...
Hi Marius,
I've created an inbound and outbound capture on the firewall. I can see translations happening but the capture do not show any inbound traffic or outbound traffic.
ASA# sh capcapture INCOMING type raw-data interface INTERNET [Capturi...
Hi Marius,
If I'm connected on the LAN, I can browse to the respective servers. If I replace the firewall with my router with source NAT's (provided in original post) I can browse to servers without any issues from the Internet.
I'm using a IP w...
Hi All,
Thanks for the assistance and help, unfortunately I'm still not having any luck. I've implemented your NAT statements and understand where I went wrong, (run config attached) but still unable to browse to internal device on the respective ...
Hi Philip, Correct yest, this object defines both the Public IP of the Dailer as well as the the private rangeIP I want to communicate over the the tunnel. Hence there is 1 Public IP and 2 private range Subnets in this object group. Regards
