Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,We will buy 25 SSL license for ASA SSL clientless VPN configuration.So, if I add the license into the Firewall, do I need to reboot the Firewall to take effect?Thanks
Hi All,I have a ASA5510 (EasyVPN server); and a ASA5505 (Easy VPN extension mode).On ASA5505, I had "internal interface" with 10.10.110.254/255.255.255.128; and "DMZ" 10.10.110.1/255.255.255.128The ASA5510 had internal ip range with 192.168.159.254/2...
Once I reboot 5505, the easy VPN will not start; and when I enable Easy VPN after boot up and if the outside interface is DHCP or PPPOE enabled.I got:* Remove 'aaa authentication listener' configurationCONFIG CONFLICT: Configuration that would preve...
Hi all,Currently, we got one 5510 in main office A, another 5510 in main office B. And we also have a 5505 in branch office C.In office A, IP range is 192.168.1.0/24In office B, IP range is 192.168.2.0/24In branch C, IP range is 10.10.1.0/24I have co...
Hi Guys,I configured Easy VPN between 5510 and 5505. Every thing looks fine, however, if there is no traffic in the tunnel in next few hours, I can not initial traffic from 5510 to 5505 (client). But if I initail traffice from 5505, there is no probl...
Hi thanks for you information. however, I do not think that is SLA issue. (May be i am not right)Because this is not two ISP, this is two IPsec tunnels.I will try cypto map tonight and give a update to you.
Thanks, right now, I did some testing.The only way can do that is:I setup the maximum connect time = 2 mins. in IPsec GroupPolicy at secondary 5510.Which means every two mins, all EASY VPN has to re-connection to secondary server.Then, once the prima...
WOW!!!! Thank you so so much Scott. You save me.Yes, I disabled RADIUS service. Then, the Admin account got work. And I move the Local authentication above of the RADIUS, and enabled RADIUS server.Every thing works fine!!Thanks again, you saved my ti...
Thanks a lot.Well, as your said, I had disabled and enabled management of the RADIUS server because I was testing multiple RADIUS failover. And also, I have changed authentication priority of the WLAN, I moved RADIUS above of Local.By the way, I call...
