Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,
Anyone has experience with floating ip address and BGP in ACI? As far as I know BGP is not sending Hello packets using floatng ip address. Configured and tested it in physical domain, but did get the BGP neighborship up.
https://www.cisco.c...
Hi there,
I have some questions regarding Netflow in Nexus 9000 series.
1. Can we mix in flow record Layer 3 and Layer 2 match clauses and apply it to Layer 3 or to Layer 2 interface? The idea is to see in Netflow collector both Layer 2 (MAC) and Lay...
Hi Folks,
How do you monitor disk usage in APIC using REST API? Found the below mentioned request, but I am not sure which values I need to monitor. Need to get the values general size, used size and free size of the disk space/RAID in APIC.
http...
Hi guys, Need some inputs regarding my thoughts.I have 2 L3outs (L3out-A and L3out-B) in VRF-01 and one server in VRF-02. 10.111.10.0/24 is learnt and mapped to L3out-A in VRF-01. The server in VRF-02 needs to learn 10.111.10.0/24 too. VRF Leaking wi...
I think sflow is the way to go with gathering layer 2 and layer 3 information from layer 2 interface.
feature sflow
sflow collector-ip xxx.xxx.xxx.xxx vrf default source yyy.yyy.yyy.yyy
sflow agent-ip yyy.yyy.yyy.yyy
sflow collector-port 2055
sflow d...
According to the guide we can apply Layer 3 Netflow to Layer 2 interface. Tried to apply to Layer 2 port-channel and got the following error.
Configuring Layer 3 NetFlow on Layer 2 Interfaces
You can define Layer 3 flow monitors on Layer 2 interfac...
Your answer shows that we can apply Layer 3 flow monitor to VLAN. Yes, Cisco guide says so too. How can we apply Layer 3 flow monitor to VLAN? What is the command?
From Cisco document: Layer 2 switched flow monitors are applied only to Layer 2 inter...
Hi Sergiu,
Thank you very much for your help. It works for Leaves and Spines. https://{{apic}}/api/class/eqptStorage.xml is for APIC. But too many values in the reply. I would like to know which values I should monitor regarding disk space in gen...
Hi Chris, Sorry for my late response. Was busy. I am grateful to you for having time and asking all my questions thoroughly. Helped me to add some bits to my ACI knowledge. Thank you very much! Best regards,Amal
