Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm having some issues with separating traffic on my UCS. I have a Lab environment and a Prod environment. I'd like to have two servers in the UCS chassis be on the Lab net and 2 servers be on the Prod net. Both environments have the same...
I have a question about the "sh ip EIGRP interfaces detail" and what it shows. When I do that command to show the interfaces hello/hold time configuration and stuff, it doesn't show me the physical interface that EIGRP is using. The interface has a ...
On my Cisco switches, I have configured them to send to a linux syslog-ng server, which is working fine. They were sending their messages with the timestamp, which then on the syslog server shows them with a double timestamp. I can eliminate this b...
I have a bit of an odd situation. At my DR site, I used to have 2 3560 switches that were port-channeled together. I recently swapped those switches out for 2 3750X switches in a stack, and copied the identical configuration on them as the original...
Hi, I have an ASA 5510 running 8.2(5). High-level, I'm looking to have two different internal networks use two different public IP addresses.
Right now, I am using the global pool for doing a dynamic NAT for all internal networks out the outside i...
Couldn't agree more. I've been fighting with this for months now, and they keep saying that they don't see anything wrong with their circuit, but yet I continue to get eigrp drops periodically. The line is used for data replication to a DR site, so...
Thanks everyone for helping me understand this a lot better!Just a bit of background, my network provider is telling me to increase the timeout because I’m getting periodic eigrp drops where I lose my network then it comes back up within a minute whe...
Thanks for that good explanation. I understand what you're saying. So, if I were to set ip hello-interval eigrp 100 x and ip hold-time EIGRP 100 x settings, I would do that on the vlan980 interface and not the te1/1/1 interface, correct? Also, I've...
