I have a question about the "sh ip EIGRP interfaces detail" and what it shows. When I do that command to show the interfaces hello/hold time configuration and stuff, it doesn't show me the physical interface that EIGRP is using.  The interface has a ...

On my Cisco switches, I have configured them to send to a linux syslog-ng server, which is working fine.  They were sending their messages with the timestamp, which then on the syslog server shows them with a double timestamp.  I can eliminate this b...

I have a bit of an odd situation.  At my DR site, I used to have 2 3560 switches that were port-channeled together.  I recently swapped those switches out for 2 3750X switches in a stack, and copied the identical configuration on them as the original...

Hi, I have an ASA 5510 running 8.2(5).  High-level, I'm looking to have two different internal networks use two different public IP addresses.   Right now, I am using the global pool for doing a dynamic NAT for all internal networks out the outside i...

Hello, I'm having a strange issue, and maybe this is related to me trying to do something that can't really be done, but I'd like to find out what's going on.  I have 5 sites all connected by a layer 2 mesh Ewan circuit.  Two of my sites, HQ and DR i...