Buenas tardes Tenemos unos dispositivos WAP150 conectados a un enlace de 200 mb, realizando la prueba de conexión el WAP150 nos muestra como resultado de la prueba de velocidad de 9 mb. Se reiniciaron los dispositivos a valores de fábrica y no se obt...
Hi everyone, I have an SG300 52 ports PoE but when I'm trying to enable IP ROUTING via CLI, the command down's appear, and by this mean, all the inter-vlan communication is being blocked, do you know what am I doing wrong?
Yes, right now there are no ports on the other VLANS, but when the switch was on a productional environment there was ports on the other VLANS and the result was the traffic inter-vlan blocked, and still ip routing command, was unable to set it.
Thank you again, but I also did that already, let me attach my sh run:
config-file-header
CORECA
v1.4.0.88 / R800_NIK_1_4_194_194
CLI v1.0
set system mode router
file SSD indicator encrypted
@
ssd-control-start
ssd config
ssd file passphrase cont...
