Dear All,We have a CSS11506- in which the internal SSL-certificate is getting expired.Please revert on the steps for changing with a new certificate.Should i generate a new csr ? Thanks ,
Hi, We are planning to migrate the existing licenses and Data from CCM 4.1 to a New MCS Server with CUCM 8.5 .The old server is end of life and no valid SMARTNET.1.What are the items to be ordered ?2. What is the procedure for migrating da...
HI,I find that this Cisco 4503 supervisor II plus TS only supports IP BASE IOS .Is it possible to configure Policy based Routing ( PBR) ??Thanks in advance.Regards,Magesh
Hi,I have one 4500 Core switch and currently have one DHCP Server .But now the client requires one more DHCP Server in their network for redundancy or Failover in the same VLAN.Is it possible to have multiple DHCP servers in a single VLAN ??Pls adv...
Thanks a lot Sachinga .. this was so useful .!!Please do confirm the below syntax,CSS11506(config)# ssl genrsa rsa1024.pem 1024 "system"What is the " System " keyword used in the above syntax ? is it the password ?Also do we need to delete the old ...
hi ,thanks for the reply...If we have multiple vlans in the network.. is there any changes to be done to VLAN interface config in my L3 switch ?currently i have one ip helper address < dhcp server 1> configured on the vlan interface .Please revert.T...
Following things from Cisco.com helped in completing this task...It works now..Thanks to Cisco.comIn Cisco IOS Release 12.2(40)SE and earlier, each 10/100/1000 PoE port provides up to 15.4 W of power to the device. Cisco IOS Release 12.2(44)SE and...
The Service uses Primary-4ess that is for sure !!Also the provider says that my PRI Channels except channel 31 are getting blocked , due a " unknown potential being sent from my device ( voice gateway) ".pls advice