About DantePasquale50

DantePasquale50 · 04-22-2014

Hi,We have just built an MS Exchange 2012 R2 server and need to configure the "Mail Flow"/connectors properly to send outbound emails to 2 IronPort devices and allow inbound email from those 2 devices.I am able to telnet from the Exchange Server to b...

DantePasquale50 · 09-04-2013

Hi All,Not sure if this is the proper place to ask this, but in the logs on one of my Catalyst 3560 switches that we are using for VLAN routing, I get an NTP PEER Unreachable, but for an IP Adress that isn't configured on the switch. Any ideas how/wh...

DantePasquale50 · 09-21-2011

Hi,I need to setup a small company's network and will only need 2 vlans. They have a 2901 and a number of HP Procurve switches. The two vlans will be 126.10.0.0/22 and 126.10.4.0/22. The 2901 needs to be able to route between these 2 vlans and from t...

DantePasquale50 · 05-06-2014

For the "Recieve Connectors" we reset everything to the default and made sure "Scoping" for all was open to 0.0.0.0-255.255.255.255For the "Send Connectors" we made a new connector called "IronPort" with the following properties:Delivery: Added 2 sma...

DantePasquale50 · 04-22-2014

Definitely a good answer and very helpful information! We had an Exchange Expert stop by today and check out the setup. It turns out I had way overcomplicated things. I'll document them tomorrow and update this post.

DantePasquale50 · 09-21-2011

Honestly, there is very little lan traffic and almost no WAN traffic so I think they should be OK until they get serious about their web presence.Just curious, how is performance if you add the SFP/SFP+ modules or whatever they are called ? The ProCu...

DantePasquale50 · 09-21-2011

Hi Jon,Yes, there is internet connectivity, but they have an appliance for firewall/content filter that will sit between the 2901 router and their internet gateway (something through Time-Warner-Cable, that looks to me like DSL). So, I'll need to rou...

Member Since	‎09-21-2011 12:38 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

Exchange 2012 R2 Email Flow to/from IronPort C170

NTP msg on Catalyst 3560

2901 Router intervlan routing

For the "Recieve Connectors"

Definitely a good answer and

2901 Router intervlan routing

2901 Router intervlan routing