About samavedula_rama

samavedula_rama · 01-31-2013

Hello,Does anyone know how the port numbering would be on Sup 7-E and Sup 7L-E? I mean, on Sup-6E and Sup-6LE, if I used a twin-gig converter, I used ports gi3/3,gi3/4,gi3/5 and Gi3/6 [If the sup is in 3rd Slot]. I know there are now 4 ports on the S...

samavedula_rama · 04-27-2011

Also use 'mpls label-protocol ldp' just for the sake of it. Would be good if you posted the diagram mentioning where you run MPLS on.Thanks.

samavedula_rama · 04-25-2011

May be the provider is using "neighbor as-override" to make sure your routes are not discarded by the remote router ?? So, if your remote site is also on the same AS as yours, they might not see these routes at all, since they see the AS in the AS-PA...

samavedula_rama · 04-22-2011

Yes. On Cisco Gigabit Fiber port, you can only ask it to either negotiate or not.You should try to use "speed nonegotiate" and see what happens. Also, do you have a media converter in between both the switches?

samavedula_rama · 04-19-2011

Did you useatm route-bridged ipon the ATM sub-interface?

samavedula_rama · 04-19-2011

Oops, I was looking at something else. The one I gave was for bridging a vlan and an ethernet port.There is a way to bridge a FR PVC and Ethernet with the following command.frame-relay map bridge broadcastI will check if there is ATM substituteReg...

Member Since	‎03-17-2011 08:44 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	47
Total Helpful Votes Received	11

User Statistics

User Activity

Supervisor 7-E 7L-E port numbering

Re: 6500 MPLS command under layer 2 interface

Re: Influencing BGP routes with MPLS provider

Re: Physical Fiber Connection Issue

Re: Bridge btw pvc and vlan 1

Re: Bridge btw pvc and vlan 1