I am using the following Mobility Express DCA channels configuration, do you think can be good not u...

But, it's strange, most of the clients prefer the smaller cell, because AP1 has got a transmit power...

Thank you. I was doing the opposite, increasing the power in AP2.Considering I have very few 2.4 GHz...

I have a rectangular auditorium with 2 APs diagonally and 1 AP outside as a backup. The 2 APs inside...

Thank you for your help.Sometimes I increase the transmit power due to 2 different problems:- In som...

Hi, I have AP's that are transmiting at low transmit power in the 5GHz band. I set the transmit powe...

Hi. I think something like 80% must be considered as normal. While you don't arrive to 85% or 90% yo...

I have a Mobility Express configuration. The controller is AP 3800 with 8.10.121. When clients are c...

I have Efficient Join enabled, I will try to disable it and I amb going to upgrade to 8.10.121I thin...

I have a ME installation. The controller is a AP-3800 8.10.112 and there are 23 AP's and 5 WLAN's. I...

No, sorryIt seems ME makes the channel changes very slowly, and the end it changed

I have needed to select channel pairs and I have been able to enable 40 MHz globalyBut the AP's rema...

when I try to fix channel width to 40 MHz in Advanced - RF Optimization, I receive the message "At l...

Thank you very much.What lower date rates do you recommend to disable?You say "Remember on 5ghz you ...

In my testing, Apple devices prefer connecting to a poor 5 GHz wifi than connecting to 2.4 GHz. And ...