Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Environment: PBX in basement with fiber feeder to second floor. PBX does not support an IP conference room phone but all other desk phones are VOIP connected to a card in the PBX. I need to get an analog extension to the second floor.How do I conf...
Hi everyone,I'm having an odd problem with setting up CIFS in the ASA WebVPN. It works fine with a windows share but not with a samba share. Attached are debug logs from the asa on multiple fronts: debug aaa authentication enabled at level 1debug ntd...
Hi All,I am having an issue with CUE and MWI not working. I have it setup but it's not working and I'm getting some odd errors in the debugs. It is NM-CUE 2.3.2 running on a 2811 with IOS 12.4.9T1. Config items:dial-peer voice 100 voip incoming calle...
I finally got this working using the link offered by Howard. My mistake was using the Ethernet ports vs. the WAN ports. Also, had to change the line voltage from 30 to 23 otherwise got fast busy on the phone attached to the remote SPA.Thanks for y...
I wish it were that simple. That part already setup. Is there something in CME I should be looking for?msageunity01# sh ccn subsystem sipSIP Gateway: 10.7.95.1SIP Port Number: 5060DTMF Relay: ...
Here are the router's SIP Call Message tracing and SIP media debugs. Also in these is the 404 error.Dec 5 20:18:23: //-1/xxxxxxxxxxxx/SIP/Msg/ccsipDisplayMsg:Received:INVITE sip:11099204@10.7.95.1:5060;user=phone SIP/2.0Via: SIP/2.0/UDP 10.7.96.50:5...
