Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok, following the CCX Ordering Guide, Social Miner needs to be ordered with the following part number:CCEH-CCP-SVR-LICHowever this part is showing Invalid when we attempt to order it. Is there a top-level part # that this needs to be ordered under?T...
Can someone share the top-level part number required to add Adjunct licenses to the CMBE6k? The part I need to order is LIC-BE6k-ADJ but cannot find the top-level part number it belongs to. Thanks!
We recently purchased two Cisco compatible 512 MB flash drives for our ASA. The drives work fine when first inserted into the ASA. We are able to load boot images, ASDM, CSD on the flash cards. However, when we change to boot statement to boot off...
Per this page, it says that the NotificationApp supports SNMP monitoring of CPU and memory usage:http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a00804cf52e.htmlWhat are is the MIB needed or just the OID...
We have two ASA5520's running in Active/Standby failover configuration. Both ASA's have ASA-SSM-10 IPS modules. The ASA's are running 7.0(2).My question is how does the IPS module affect failover? When upgrading the IPS modules to 5.1, the ASA's f...
I'm looking for the part number to *add* Adjunct licenses to an existing CMBE6k deployment. The UNIFIED-CMBE6K part number is being deprecated in favor of the new CMBE6K-UCL and CMBE6K-UWL top level parts.Thanks,-Jon
Ramu-Have you used the "management-access" command to enable management access to an internal interface when connected via VPN?http://www.cisco.com/en/US/customer/docs/security/asa/asa80/command/reference/m.html#wp1987122For example:management-access...
Turns out it that both CF cards we had wouldn't work, even though they were Cisco compatible. Tried with a different brand of CF card this weekend, and both ASA's were able to see disk1 at boot time.Thanks,-Jon
There's a Troubleshooting Technote article on troubleshooting calls stuck in queue:http://www.cisco.com/en/US/products/sw/custcosw/ps1846/products_tech_note09186a00801c82ea.shtmland one that details the traces required to debug calls stuck in queue:h...
