Hi!I have FWSM running 4.1(6) with two security contexts.The context test config is:FWSM/test# sh run: Saved:FWSM Version 4.1(6) <context>!hostname testdomain-name fwsm.spbstu.ruenable password 8Ry2YjIyt7RRXU24 encryptednamesdns-guard!interface Vlan5...
Hi!Could you tell me which command should be used instead of "track 50 rtr 50 reachibility "when I use Cisco IOS Software, 1841 Software (C1841-IPBASEK9-M), Version 12.4(9)T1?
Hello, Everybody!Could you explain or give some links to the documents the can explain how destination nat is configured on Cisco routers?For clear understanding the task is to do the same as Linux iptables netfilter does by following command:iptable...
I have configurated pptp server on Cisco router with following:vpdn enablevpdn-group 1accept-dialinprotocol pptpvirtual-template 1exitip local pool test 192.168.1.1 192.168.1.250interface virtual-template 1encapsulation ppppeer default ip address poo...
access-list permit_any extended permit tcp any anyaccess-list permit_any extended permit udp any anyaccess-list permit_any extended permit ip any anyaccess-list permit_any extended permit icmp any anyaccess-group permit_any in interface insideaccess-...
yes, but with a kind of exeptions: route-map redir-map match web-traffic set ip next-hop 172.16.0.2if that is not the final destination than you should configure that 172.16.0.2 router also
Thank you.Actualy, I need to change outside global address for packets coming from local inside addresses.So, it should be done before routing process in most cases, but according to NAT Order of Operationhttp://www.cisco.com/en/US/tech/tk648/tk361/t...