Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am trying to implement Multicast Service reflection in my network as the end user device does not support multicast-routing.
There are around 25 video streams which are needed to be streamed to the end user.
Can someone help me understand Mult...
Hi
I have a Cisco 6500 series L3 switch and have to implement multicast routing such that the recievers belonging to one VRF can recieve multicast stream from SOURCE belonging to other vrf. Both the VRFs are on the same switch.
Cisco IOS is: s72033_...
Hi,
Our company is planning to implement IPTv services in our network only for a single VRF(Orange)
We have partial mesh iBGP topology with ospf as the IGP.
we have a demo IPTV server along with set top box. For the Set top box(STB) to recieve the ...
Hi...
Client------- 3750----7600-------7600----3750------------Client
We have MPLS L3 VPN topology on which we have to implement L2VPN for a client.
3750 is connected to PE(7600) is configured with trunk interface carrying data of multiple V...
hi Victor,
The source and the RP are in the same VRF.
How can i stop this from happening and can this crash my switch?
Today I got the same log except for different (S,G)
Regards,
Roque
Hi Victor,
(10.190.4.175) is not a source for any multicast group. It is just a host in the reciever VRF.
Also i have not configured Bidir flow .
Could this cause any harm to the switch because its in a running network.
Thanks,
Roque
Hi Victor,
I did what you said and it Worked!!! The folllowing log was observed in the switch.
MLSM[4]: mlsm_process_pending_event ERROR in processing (10.190.4.175, 239.192.152.143, Vl25) 0 eventMLSM[4]: mlsm_process_pending_event ERROR in processi...
Hi Victor,
Thanks for the reply. I am considering to use the extranet feature.
Unicast routing is working absolutely fine.
From your configuration, it seems that I only have to configure same RP for the reciever VRF statically.
I have one more dou...
Hello Douglas,
As suggested by you, we configured svi based EoMPLS scenario by refering to the sample configuration you provided through the Link. In that case, the pseudo-wire between PE-A & PE-B wont come UP.We tried with the below scenario using ...
