Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,i am upgrading the router from 1900 to C1101-4P line and facing some QOS issue, when i try to set the service-policy in the tunnel 204 and 298 the following message is showed: Output queueing feature not supported on vlan1020 config cla...
Hi guys,
i am facing a problem since we decided to enable ipsec over our Mpls tunnel, our enviroment already have Ipsec enabled in our backup link that uses wire internet, the problem came up when try to enable it over the Tunnel that cross our mpls...
Hu Guys,
i recently replaced my older Router cisco 1800 to a new one of the family C1900 Software (C1900-UNIVERSALK9-M), Version 15.2(4)M3, i have a template snmp that get (RFC1213-MIB::ipRouteNextHop.10.0.0.98), unfortunately after this router cha...
Hi Guys,
i am needing some light to solve an issue that came up this week, in attach has an image of my cisco 1841 Software (C1841-ADVSECURITYK9-M), Version 15.0(1), i am facing a CRC number raising so i am concerning about it, can you someone hel...
hello,sorry for being late to answer.Do you have QoS config on the Physical Interface where VPN Terminates ?Do you mean in the other side where this vpn will be tunelled ?R14#sh versionCisco IOS XE Software, Version 16.09.04Cisco IOS Software [Fuji],...
Hi dear,it is already there have a look, it is very crazy situation .... because itwas working exactly like that so sometimes you rebbot the both side itreturns to work but then the vpn goes down ... sometimes you reboot bothand no one comes back !!!...
thanks for the light but i am still having some issue to identify theproblem, could you please point the problem in the line or show someexample.thanks,
Hi Dear,
thanks for your interest to help, instead i didnt need to go further to resolve the problem, as both side was showing active ipsec and even package exchanging so i just remove the tunnel and added a new one to fix it.
thanks !!!!
Hi Dear,
could you please give some extra details how do i hard coding speed ? please check below some detais of my interface affected.
R18#show interfaces fastEthernet 0/1FastEthernet0/1 is up, line protocol is up Hardware is Gt96k FE, address is...
