Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Expert Team,Could you advise if there`re any concurrent session limitation on WSA S390 appliance? The reason I am asking is that we`re facing with intermittent issue on our WSA when users are getting error on their browser when they have to ref...
It`s strange, but I configure clock source to be internal on two E1 (clock source of other 4 E1 forming multilink are line) which are connected to telco circuirs and all Slip Secs error disappeared. I did not configure network-clock-participate at al...
Hello,I do had the same problem, and I put clock source internal under e1 controller and Slip Secs error had gone. I have 6 E1 interfaces bundled as multilink and one of the interface kept getting error which was caused time out after some number of ...
