Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two Cisco 4431-isr routers, running the same ios and rom-mon but the show commands are slightly different.one router will accept the: 'show DMVPN' command and the other does not recognize the show DMVPN command. What would cause this and how ...
output:SHOW ip nhrpTunnel 1 created 00:-1:03 expire 00:02:01Type: incomplete, Flags: negativeCache hits:2other than the spoke failed to connect to another spoke what is the next step in resolving the connection issue.The outside of each spoke router ...
This is a closed network running DMVPN phase 2/3 with two hub routers/sites and multiple (100+) spoke sites. The issue the network is having is a couple of spoke sites fail to connect to a couple of other spoke sites but are able to connect to a majo...
I am looking to expand my routers HSRP configuration by adding ether-channel to the router configuration.When configuring HSRP and ether-channel on a router is the hsrp configuration on the fiscal interface or in the ether-channel configuration. I h...
We have a number of sites with routers running DMVPN with IPSEC. With VPN connections to each other in a full mesh environment.We would like to replace/refresh the routers IPSEC config-key on a routine basis with no or minimal interruption to the sit...
GiuseppeThanks for the input, Both routers IOS was loaded with the same IOS image (16.09.06).The License was the same other than one had 'HSEC license' enabled and one did not.The show DMVPN command worked on the router with HSEC enabled.bymc
Paul,I am unable to restart/bounce most of the sites tunnels due to site activity. I found multiple sites with the same issue and was able to bounce two sets of the sites tunnels.In one case this recovered the site to site connectivity between these ...
I removed the line " ip nhrp shortcut " from the spoke routers DMVPN configuration. These two sites DMVPN connection is still down.Router-1 DMVPN IP: 172.16.19.2 and router-2 DMVPN IP: 172.16.19.4Now on one of the spoke routers in question from route...
The Spoke routers are Cisco 4300isr, both spokes are running IOS-XE version 15.5(3)S4B. The Hub router is a ASR1001-X running IOS XE version 15.5(3)S10.BYMC
