Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'd like to configure a temporary design and I have somes questions about vlan utilizationI use 2 x 6500 chassis linked together and on each I have a link that goes to L2 switches. 6500-1 -----------------6500-2 ...
Hi!I have a particular installation on a customer site.The management vlan is the number 1 (which is the native vlan) for the whole network and all the switches tag the native vlan.So when I plug my AP on a port of a switch configured in trunk mode, ...
Hi!I'd like to differenciate users sharing the same ldap directory and radius authentication.For example, if I have a student and a teacher, i'd like to be sure that the student will stay on its vlans and so on.I can do this by using vlan attributes ...
Hello,I have a lot of alert messages from my APs and I don't understand what it means exactly.Can anyone help me?Here is the message (on DFM - Alerts and Activities):Event_Description OperationallyDown Component PORT-AP-1200-VINC33/7 [Fa0.1] Type L2V...
Not sure i follow. Each 6500 has an etherchannel trunk to it's respective L2 switch. And you run sibinterfaces with HSRP on these trunks ? ==> yes, I have HSRP on sub interfaces so the HSRP communication is through the L2 switchesSo how did you cre...
Hi Jon,I have 2 different configurations because I'd like to do a migration, so it's just for few days.Actually, I have on both chassis a etherchannel that goes to the switches and on it I have a lot of sub interfaces (port-channel subinterfaces). I ...
Hi,Thanks for your reply.But when I created first the vlan 3061 and then I declare the Po2.3061, I also have an error :Command rejected: VLAN 3061 not available
