Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Is there any possibility to do a rapid ping vrf in Cisco. I found the pramater repeat but is this a rapid ping ? if so what is the ping interval ? Can we change it ? For exemple in Juniper or Alcatel we can find the parameter "rapid" i can't f...
Hi everyone,A customer reported that their router experienced spikes (high cpu utilization) every 4 hours and claims that it is caused by snmp polling of the Ciscoworks serverThe process SNMP engine is the process that causes these spikes .We think t...
Hi All,We have 2 Cisco 7609-S router with SRD3 version . We have detected a very strange behavior when we insert a new RJ45 into one of them HSRP start to flap (vlan pass from inti , active ; standby etc ) and we have a total loss of service. The pr...
Hi all,I have this topology Server .2-------1.1.1.0/24------------.1 Cisco ASA-----------------ADSL Router...................INTERNETI want to configure remote access in ASA in order to access to the server address 1.1.1.2 through INTERNET.Natting wi...
Hi Joseph,Just to explain we have exactly the same problem. Below is the show stack. Could this be related to the same VNM pollin*Sep 5 12:02:43.230 GMT+1: %SYS-1-CPURISINGTHRESHOLD: Threshold: Total CPU Utilization(Total/Intr): 56%/14%, Top 3 proc...
Hi Joseph,Could you please tell us how did you manage to idenfiy that the problem is related to VNM Mib ? Is it through the show snmp stack command ? iThank you Zied
