Hi Marcelo,Which version of are you trying to install? If it is 1.5 version than you do not need to configure MGF IP address. For 1.5 installation look at the the following:http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/sre_v/1....

Hi Ivan,The currennt Hardware and UCS express software supports RAID 1 for Hard drisk for redundancy.  The SRE hardware on which the software run also has three NICS so you configure NIC teamimg in ESXI for network failover scenarios.Thanks,Radhika

Hi Juan,It is possible to reconfigure RAID Option after installation but we advise you to do this only after you make sure you have a back up of the data on the datastore as you might loose data if the raid configuration and migration  is not done c...

Hi Doug,You are exactly right remote office in a BOX is the one of most important use case for UCS express.The next generation of hardware with more powerful Intel processor and more memory will be available in FALL of 2012. For more details on this...

Hi Eric,This forum is for discussion on UCS express produc and not the right alias for Siwtching questions.  I hope you have got the help you need to resolve the issue if not please contact cisco TAC.Thanks,Radhika