Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community,
I'm having a Catalyst 6800 VSS with multiple L3 uplinks to routers.Each of these links are dedicated L3 without MEC.
Is it recommended to use BFD on these interfaces or not?
Especially what happens if my active Sup fails, does it bring...
Hello community,I'm planning a upgrade procedure for a Nexus 7000 vPC enviroment with M1 I/O modules to M2 I/O's.I have already contacted TAC and Cisco engineering about this upgrade. Unfortunately I have received different answers about a possible m...
Me too, even with managment-access inside
After software upgrade the login was not possible anymore.
I removed the management-access from config and reconfigured it. That fixed it.
Hi,
thank you. My problem is a indirect connection via some provider hardware.No link-state is propagated to the partner router.
I think I have found an answer in the meantime:
SSO—BFD
12.2(33)SRE
12.2(33)SXI2
12.2(33)XNE
15.0(1)S
15.1(1)SG
Netw...
Amit Singh schrieb:option 1:Do you mean to replace the I/O on both sides at the same time?Answer : No, Just do it one-one. Shut down the PL on Primary VPC peer. Secondary will put all the interfaces to down state. Then change the I/O on secondary to...
I have received the answer that it is supported to mix M1/M2 I/O modules for PL and PO on both peers. But with is only supported with NX-OS 6.2(2).So having M2 modules on the left hand side and M1 on rigth hand.Amit Singh schrieb:What is the Answer/c...
