Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We will be installing Nexus 7K and 5K switches soon and wish to implement Fabricpath. Our end-user switches are Catalyst 2960s. These by default run the spanning-tree protocol. Is it possible to enable Fabricpath on the Catalyst 2960 series of s...
We are considering using the above cards in a DDR/Dialerwatch backup solution rather than ISDN.I have read the Q&A on the cards on the Cisco website and it states that multiple cards in the same router can be employed for bandwidth aggregation; howev...
I have a WLC 2106 with 4 lightweight WAPs directly connected to it. The 2106 has an 802.1q trunk to a layer 3 device. The WAPs are registered and work fine; however, although I can 'ping' the controller from the layer 3 device I can't ping any of th...
I have a 4402 wireless controller whose management and ap management interfaces are connected to VLAN1 with the WAPs on VLAN17. When I confiigure the 4402 I have to assign the ap manager interface to VLAN1; however, if I try to assign the managemen...
Thanks for your reply. I looked at the document you posted on a number of occasions but cannot see any reference as to HOW you configure the cards to link them together. The document only shows how to use DDR with one card.
Not sure what you mean by that. The WLC is not connected to a Cisco switch. The connection is to a Checkpoint Edge Firewall. The port on the firewall is set to be an 802.1q trunk and is passing traffic from various other subnets apart from the s...
