I have a WAN routed between 2 L3 Cisco 3560's. Currently the firewall on lets call it the "A" side is the default gateway. I have a new Cisco 2821 router to take the firewalls place as the default gateway. Currently the firewall has a route config...

I have a Cisco 2821 Router that I am setting up to be the default gateway. The router has 2 gigabit ports. Should I:1. Use only port g0/0, set the gateway IP on this port and create a route of this port to the firewall?2. Use both ports g0/0 and g0...

I need some help. I need to configure 2 3560's to route to each other connected via a MetroE PtP setup with a dot1g tunnel. One side uses a firewall for its gateway, the other needs to use the route on the switch for its default gateway. I would li...

I need some help configuring 2 3560's to route across a Metro E, both using port 49 with subnets 192.168.0.x routing to 192.168.1.x