Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there any tweak or fix for failing RRI after a failover. Some tunnels recover ok, others seem to time out after a while and other will just plain fail. The clue is all TX and no RX...clicking RRI, save, click RRI again, tunnel drops and then com...
I have 2 ASA's connected to 2 ISP's. One with default originate metric 1 and the backup with default-originate metric 5. how do have one specific network use the backup as a primary? Lets say I have 10.0.0.0/8 use primary but I want the specific 1...
I have a thread over on the VPN General list for this. It seems I'm having a route-policy issue. Any thoughts from the routing section? I can't get VPN users access to the internet. I'll post my current config. Thanks
Hey Marc, No problem. I actually saved 5% turning that off but we are no were near your usage. The "concern" was actually another problem that has since been fixed and I may actually turn it back on. Even with it on I think I'm still under 40% on ...
AHHH, I didn't realize what I was looking at. I enable those from the dashboard not realizing thats the same config under Config/Firewall/ThreatDetection. I turned mine off and only saved about 5%.Chris
Thanks Marc for the insight!Are you using the new dashboard stats as well? I was going to turn those off and see what happened.Thanks again!Chris Harwell
yes. it was on 12.4.2 or .4 code. It was defferred so that is how it got bumped to 12.4.11 and then back down to .9. should I go back to a 12.4.2 or .4 version to see if that fixes it.
