Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is "C9400X-SUP-2" compatible with "cvr-qsfp-sfp10g" adapter?We need to utalise 6 10Gbps SFP+ ports, but we only have a C9400X-SUP-2 with only 4 10Gbps SFP+ ports and 4 (3 usable) QSFP ports.The Cisco Optics Interoperability Matrix does not list the S...
I am RDP'd to a laptop with a console connection on COM4 to a 3850, I open Putty and each character I type is wrong, inconsistently wrong...for example, the following output of what I get from typing the letter "a" repeatedly: Switch#qu}yyuqy|q~yuy...
Hi,I have two DMZ on an ASA running 9.9 which use separate public IP to the LAN, and this all works fine, traffic from DMZ2 (10.3.3.0/24) is NAT'd to 1.1.1.4 etc - see attached diagram. What I'm having problems with is I now need to forward inbound t...
Hi,Hoping I can get confirmation on the following, please?An ASA5505 with 50 user licence, showed 52 inside arp entries, but the show local-host shows "Current host count: 29, towards licensed host limit of: 50". However, when the arp entries hit 52 ...
Hi,I'm trying to confirm some details on GRE tunnelling, I hope someone knows the answer to, or can point me in the right direction, please?Firstly, is traffic still encapsulated and GRE packets routed according to the underlying network routing, eve...
Hi,Thanks for the reply.The "cvr-qsfp-sfp10g" is an adapter for dropping a 40Gbps QSFP port down to work with a 10Gbps SFP+ module. It's part number only appears in the matrix notes pop up when it is required for a device to work with a particular SF...
Hi,
Did you have any success? I have a similar issue with Modbus RTU packets in on a serial interface, but the xconnect command is only available with HDLC and PPP port encapsulation, both of which puts the serial interface into a down/down state.
