Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello i would like to ask, in past i just had 1 hub router and many spoke routers and usually I created /30 between hub and spoke to form adjacency of ospf.
Right now i have 2 hub routers, btw i just have one cable from hub to each spoke, so technica...
I have ISR 4331 that have only 2 ports, right now in my environment I have L3 switches and several access switches.
My question is, i want to have 2 ISP for redundancy, but i am lack of ports, is there a solution if i want to plug my isp cable to ac...
Hi anyone,
Is RSV 4000 have capability to do failover on WAN link? Lets say I have 2 ISP (primary and backup) and I want to make SLA tracking object like on IOS router or flexlink feature. If not, is there any feature similar that?
Hi,
I would like to ask if I have 2 block IP address from ISP 1 and ISP 2, then I would like to make 2 inside NAT map to 1 one web server, lets say :
100.0.0.10 (ip ISP 1) and 200.0.0.10 (ip ISP 2) to map to my web server.
My question is, lets say I...
Hi,
I would like to ask about vlan 4094 in nexus, as far I know that vlan is belong to internal usage of nexus. I have change the internal usage vlan to another range, but after I rebooted the nexus I still saw vlan 4094 in internal usage. Is there ...
Hi hector,
typically i rent leased line (isp forward L2 mac frame) to connect my hub and spoke, if the spoke is large branch so we have 2 leased line from different provider, but if the spoke is relative small branch, then i just have one. In case i...
Hi reza,
If i have 2 ports on router, then first port for L3 switch and second port isp 1 right? I just thingking how to plug cable of isp2 to access switch
