Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I’m trying to set up a CUBE between our CM 6.1 and a SIP provider for PSTN access. So far I can make a phone outside the PSTN to ring and even pick up the call, but the Cisco phone on the CM side keeps in ring out state and obviously there is no audi...
I forgot to mention that I reset the SIP trunk after changing the device pool, and after the first call test and the same error I reset the CUBE, just in case…
You are correct, I’m calling to my cell phone and I pick up the call, but the phone on my desk still ringing out. If I hang up on the cell phone the desk phone still ringing out. If I hang up on the desk phone, then the cell phone yes disconnect the ...
The SIP trunk was on different device pool and different region, I move it to the same device pools of the phones now.I make another test call and still see the same codec mismatch error that thank to you I now about it now, I attach a new log.Here i...
