Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a cisco router 3845 with Etherswitch modules and one Vlan configured "172.16.6/24", many switch ports are assigned to this vlan. i would like to translate one IP address 172.16.6.200 to a new one "172.25.42.10" but need to keep the other...
Hello,I would like to transport two time slots (TDM traffic) over an IP network in order to connect two telecom devices located in different sites, i have cisco 2811 routers on both sites with ip advanced services 12.4.20T IOS, could someone help on ...
Hi guys,i have two cisco 3845, on both of them are configured :- vlan100 (see below),- a trunk , - HSRPthe issue is i cannot ping the ip address 172.16.4.1 from router 2 using as source vlan 100 (see below), in the arp table of router 2, no entry for...
Hello, and what should be configured on ingoing and outgoing interfaces ? BR,mustapha.De : thotsaphon À : tdanetsco Envoyé le : Mardi 22 Novembre 2011 9h27Objet : - Re: NAT Traslation in vlan interface Home Re: NAT Traslation in vlan interface crea...
Hi,i would like to translate the source IP 172.16.6.200 to 172.25.42.10 only when i have to reach some specific IPs otherwise i don't want to translate the source IP, i want to keep it as it is. something like :if destination IP is X.X.X.X then tran...
Hi Victor,the issue was only when ping requests were executed from Vlan interface on Router2 and not from the hosts connected to it. Thank you for your help.BR,mustapha.
