About josejames

josejames · 04-12-2007

Hi,We required to setup several IOS wireless points with MAC-address authentication using the cisco acs. I have it working but the problem is that even rouge devices try connecting and this causes loads of failed attempts in the failed report, there ...

josejames · 06-05-2008

Can you send a partial config with user credentials, interfaces, ip inspect, nat If your natting then try and create a ip nat inside blah blah 22You could also confirm the ssh is functioning correctly by ssh -l %username% %ip address%

josejames · 02-25-2008

Try updating the firmware of the ADSL wic, you should be able to get the instructions and firmware from cisco's ftp site.

josejames · 04-14-2007

Hi,The ideal solution would be if I could disable or rate limit the failed authentications for a specified device in the ACS.

Member Since	‎04-12-2007 02:19 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	4

User Statistics

User Activity

Wireless ---> Cisco ACS (To many logs)

Re: can't ssh to 2811

Re: cisco 2620xm + wic-1adsl limited

Re: Wireless ---> Cisco ACS (To many logs)