Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All- not sure if this is possible but is there a work around to have two different PFCs operate on the same switch.The situation is that the standby Sup720-PCF3A has crashed and will not sync up with the active Sup. Replacement is a Sup720-PFC3...
I have a Cisco VPN client that I connect to a client. The tunnel comes up when on the office LAN, but I can not PING or connect to the servers anything across the tunnel. The same works from my home. I have a Checkpoint Firewall allowing "any" servic...
Hi - Am looking for technical information related to deploying and configuring VRFs in a network. Also, basic info on VRF tables,L3 associations., etc. Thanks,KC
Trying to pass traffic thro a FWSM and I don't seem to be getting anywhere. if someone knows how to, that would help a lot. Sample config below..System Config >>context Laballocate-interface vlan101allocate-interface vlan201config-url dis:/admin.cfgm...
I did not try that as the site is a monitoring center. Act of congress to get this done..Stand corrected but if the switch is booted with the new Sup in slot-6, it will not load the current config as it's not in sync with the active Sup.Can i copy th...
i have the Sup in the chassis & when I check the status, I see it as "unknown". 5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAD084507SW 6 0 Supervisor-Other Unknown Unknown
Edison, thx for the post. If i understand, are you suggesting that I can change the redundancy mode from SSO to RPR & it should work ? If otherwise, please confirm.ThxGeorge
Try this...!interface Multilink1ip address peer default ip address ppp chap hostname <> ---> optionalppp multilinkppp multilink fragment disableppp multilink group 1!bond the two serial interfaces via the ML-PPP bundle. !interface Serialx/x/xdescrip...
