Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dear all ! I've configred EoMPLS. I've got a problem with it: VC status always down but neighbour is up. diagram is :R3--(f1/1)--(f0/0)--R1--(E1/1)--(E1/1)--R2--(f0/0)--(f1/1)--R4Configuration: router 1: mpls label protocol ldp pseudowire-class abc e...
hi all !I have a question : how many vlan can work well per routed context.I created a context an add 10 vlan, it's ok and I added 1 more vlan. no error occour but i can not ping any server in that vlan thought interface is up.when i move that vlan t...
Dear all !I have a problem with FWSM. I've used ver: FWSM Firewall Version 3.2(3). and configured Failover in two chassis 6509. The firewall system have worked for 8 months but this is the second times the FWSM auto reboot. The first time has happend...
Dear All !I've used Cisco FWSM Firewall version 3.2(3).I've created 10 context , and 1 context alarm used 400% memmory while hardware memory is 1024MB RAM.I connect by console and show memory, the result is the same.Application work well.Please, give...
Dear all !I have a problem with Cisco 6509 module. logging like this : - CONST_DIAG-SP-3-HM_TEST_FAIL Module 2 TestScratchRegister consecutive failure count:2 - CONST_DIAG-SP-4-HM_TEST_WARNING Sup switchover will occur after 5 consecutiv...
hi Anthony !I've tried but I could't find any thing about that, There's no log, except module reset logs.the FWSM don't work in hard load condition. about 600Mbps in/out and 15% connection capacity.I thinks i have to send it back to warrant.pocket.
