Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, , Basically, I am trying to configure 2 IPSec tunnels, one with GRE but the other one without GRE. Can you please help check the following configuration for me ? Thanks ! crypto isakmp policy 1 hash md5 authentication pre-sharecrypto isa...
If I have 2 routes pointing to the same subnet destination, one static & one dynamic, then the static (lower AD value) route will be the one that gets installed in the routing table, right ? But, if say that the the next-hop interface to which the st...
Hello, Currrently we are using public IP as our LAN IP and we are planning to migrate our existing public IP LAN to private IP LAN. On top of that, we will assign part of these private IP reserved for static IP user, and part of these private IP assi...
Who points the the WLAN client to the according DHCP server after a successful LEAP authentication at the RADIUS server at the ACS ? Is it RADIUS server at the ACS ?
Yep, that is exactly what I did in my configuration that I showed in the first place, please check it. IT does not work....Look forward to hear from you soon.
Thank you for your prompt reply...But, what I mean is that I already have one GRE over IPSec working. But, what should I do if I need to configure another IPSec without GRE tunnel on the same physical interface. Please help
Thank you for your kind anwsers. I just read from Cisco web-site that the router's interface Keepalive timer will also have a huge impact on the HSRP recovery times. So, can I deduce that the HSRP holdtime timer is essentialy same as router's interfa...
Thank you very much for your prompt response. However, since the primary route is a static route and the secondary route is a dynamically learned route, and the primary will always remain in the routing table (as I think that it cannot detect the nex...
