Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm having a problem with OSPF, between an ASA 5585 ver. 8.4(2) and a couple of 6509 running Version 12.2(33)SXI3.Once or twice a day, the OSPF session goes down to both 6509 boxes, and the ASA loses connection to the network.With OSPF displays I c...
Hi ThereCan't find any information regarding this feature, what I have found states that it is a feature, which only is supported when Your context is running in transparent mode, is that true. ???Thanks in advance.
Hi ThereI get the following log message when I try to connect to my ASA 5520 running 8.0(3) with VPN Client 5.0.03.0560%ASA-7-710005: TCP request discarded from ...I have no problems when I connect via UDP, then everything runs smoothly, have any of ...
We are trying to connect a Voice Gateway on 2811 with IOS c2800nm-entservicesk9-mz.123-11.T3.bin, through FWSM with ver. 2.3.3To Cisco Call Manager ver. 4.1.3Trace of the traffic shows, that the router, sends the h.225 call setup in protocol q.931, w...
I have searched high and low for a document which gives me a deeper understanding on configuring the FWSM together with the MSCF3 in my 6509 Switch.Where is the Catalyst 6500 Series and Cisco 7600 Series Firewall Services Module Installation and Conf...
Hi AbinjolaHere 4 years later, we have a simular issue on a set of 5585 running 8.4.(3) they are interconnected to 2 6509's with a 2*10 Gig Portchannel.The software now supports replication off the route tabel from the active FW to the standby unit.B...
Hi RezaMask on vlan 971 is /21, so 10.7.247.254 is the last address on the subnet.I'm running a trace on the etherchannel at the moment, to get a closer look on what happens, when the OSPF neiborship is terminated / established.JesperWe have found t...
Hi PKThanks for Your reply.I have recommended 2 approaches to mycostumer.Ad 1.Move the clients that are to receive the multicast traffic onto the VLAN with the Multicast servers.Ad 2.I can build a setup with a seperat set of PIX hardware to move the ...
Hi JorgeYes, You were absolutely right, after entering the command as outlined the communication works.I would like to thank You for Your time an effort in resolving this issue for me.I will write to Cisco, so that they will include this information ...
