Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi support, i configured the Qos on a cat 9300, here is the policy-map.policy-map POLITIQUE-QOS-CENTRALclass CLASSE-VOIXpriority level 1class CLASSE-SIGNALISATIONbandwidth remaining percent 5class CLASSE-APPLIS-LANbandwidth remaining percent 70random...
Hello support.I have trunks ports configured between a catalyst 2960 and catalyst 9300.Qos marking is done on cat 2960. the mls qos trust dscp is applied on the 2960 trunk port.My concern is about the 9300 trunk port, is the cat 9300 by default trust...
Hello Support,I have a LAN with a Distribution switch 9300 and Access switch 9200. 9200 series support L3 routing, my question is about implementing L2 network with Trunk or implementing routed access Network with OSPF. which is the best architecture...
Hi supporti connected a nexus 3k to catalyst 2960 using SFP with fiber but the interfaces not coming UP.From the 3k side the interface is blinking and the port is connected.From the Cat 2960 the interface is not connected and not blinking.when i'm us...
Hi Support,i have a nexus 3k and i want to configure ospf with a stub area (area 10)i want all the connected networks be on that stub areaattached is the diagram and the nexus configRegards
