Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My 3030 concentrator (4.1) hands out a different IP address to a particular client each time that client connects until half of the IP addresses in that group's address pool are used up. It then settles on a single IP address. Is this normal behavi...
I'm trying to use a 3030 concentrator for 15-20 site-to-site VPNs. The site-to-site remote sites are other vendors. A few of these remote sites send me traffic from the same subnet (overlapping subnets). Is there any way on the concentrator to NAT...
In the VPN Concentrator gui, when you click on Monitoring | System Status the concentrator shows the following value:VPN Concentrator Type:30XXWhat in the concentrator sets this value?The upgrades to higher level concentrator models all appear to con...
If you have a Cisco IOS device (an IOS access point, for example) that authenticates users to a primary ACS server then how do you configure this IOS device to send these user auth requests to a backup ACS server when the user is not a configured use...
I have 1200 series access points running VxWorks 12.03T. I have the LAN version of Ciscoworks2000 (assume latest version). The ANI server in Ciscoworks discovers the APs but doesn't recognize them (they show up as unknown). Can the LAN version of ...
The ACS servers are used by two different divisions(two divisions of the same large corporation) and they do not want the databases to be replicated.Thanks.
I don't think I worded the question properly. The server would actually have two NICs with different IP addresses on each NIC. I would like the content switch to pass traffic to one of these unique IP addresses unless it detected that it was no lon...
