Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,The installation goes through fine, the boot order in the service profile is correct. The server just goes blank and shows a white cursor and gets stuck in this screen for a long time.What might be the problem ? Shakeeb
Hi Experts,This question is slightly differentThe topology is like this with all ethernet linksR1<---Area0--->R2<---Area1-->R3<---Area2--->R4When I check the neighborship of R3 and R4 , the neighborship is fineR3#sh ip ospf neiNeighbor ID Pri ...
I hit the same onshow version internal build-identifierKickstart image file: bootflash:///n7000-s1-kickstart.6.0.2.bin : S31System image file: bootflash:///n7000-s1-dk9.6.0.2.bin : S31 Removing and adding the vlans solved the issue
Hi John,Thanks for the reply, but this is not what exactly I am looking forI know about VLs. I want to know why we need VLs when the neighborship is established (FULL state - which means DBD packets have been exchanged and loaded )Mohamed
