Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just updated to CSPC 2.8.1 trough the CLI interface. Update went well but when start uploading the inventory to the Smart Net Total Care Portal we get an error back.
We had to revert to CSPC 2.8.01.
Any idea?
I'm getting "unable to find valid certification path error"
Did all required installation steeps as described in the "Cisco CSPC Upgrade Guide from 2017". After moving forward to section 3 using the Software Update tab in the GUI I get following mes...
Mobility feature is workind fine, but when a call from a mobile phone, which is defined as a remote destination, gets in, only the internal number is displayed, but not the calling name. We are using CUCM 7.1.Does anyone know a solution for this prob...
It happen to us as well after updating CSPC from 2.8.01 to 2.8.1, so we had to revert back to the older version. Looks like 2.8.1 is not able to handle the upload.
Exception Error TransportMode has Failed 302. We have a Cisco UCS infrastructure with vCenter installed, so I took a snapshot of the old setup before upgrading.
We have checked network, but there seems to be no issue with that. Problem happens whether gatways are mgcp or h323, different routers, IOS etc. Nothing helped. Do you have any other idea what could cause this. It happens with some calls, with some n...
