Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Not a difficult question if you know - but i don't so i thought that i'd ask When calculating frame-relay TC what is the formula? I'm getting conflicting information. Is it: tc = bc/CIR tc = be/CIR tc = CIR/bc (or be for that matter) I ...
Hi all, I'm running a 6500 and was wondering how would you make the active supervisor the redundant one and the standby supervisor active? The standby supervisor has a better IOS revision than the active one and runs fine if i add the card whilst run...
I'm doing a customer build and when i insert the line card i get the following:Switch#sh mod allMod Ports Card Type Model Serial No.----+-----+--------------------------------------+-----------------+--------...
Hi everybody,Had a bit of an issue yesterday - I was running etherchannel in the lab and decided to convert the ports back to ordinary trunk ports. After issuing the no port-channel and various switchport commands, i saw that there were no flashing ...
I'm not sure which IOS i will need. Here's a copy of the output:Switch#sh versCisco Internetwork Operating System SoftwareIOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IK2S-M), Version 12.1(13)EW1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)TAC Sup...
If you are running a Layer 3 switch with the appropriate IOS then to assign an IP address to a specific port you would run the "no switchport" command.
