Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,
Why would a switch report the same mac address of a host (IP Phone) on two VLANs on the same switchport?
switch#sh mac address-table inter Fa2/0/38 Mac Address Table-------------------------------------------Vlan Mac Address ...
Hi,
I have a host connected to a switch running on IOS Cisco IOS Software, C3750E Software (C3750E-UNIVERSALK9-M), Version 15.2(2)E5 to a port whose config is herebelow.
sh run int g3/0/33Building configuration...
Current configuration : 198 bytes!i...
Hi,I have a requirement to "bond" two WAN links to be used as a single pipe by the remote site for improved performance at the site. Current situation:A remote site has two links terminationg on one cisco 2900 router. 1 WAN link to the HQ and an...
Thanks John, Ton...
This is quite clear... done exactly as advised.. and it still doesn't seem to behave...
switch#sh mac address-table inter Fa2/0/38 Mac Address Table-------------------------------------------
Vlan Mac Address ...
Yes indeed. As a stop gap, when this happens I connect to the upstream switch that has the wrong port assignment for the mac address and shut/unshut it to release the mac address. But this happens againin a day or two.
Bruce, version 12.3(4) and alter do not have the default SSID tsunami defined and in addition have the radios disabled by default. please refer to the documentation on Cisco; http://www.cisco.com/en/US/docs/wireless/access_point/1100/quick/guide/ap11...
Had a similar problem but anytime I setup an AP by first creating the SSIDs then enabling the radios... in that order the problem ceased. No technical explanation. Am glad you have brought this up.
