Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently using MGCP on CCM 5.1 to handle all outbound calls through the VG fxo cards. That part works fine. I am unable to get incoming calls to my IP phone. Could someone help me with some assistance maybe something I am missing on the VG. Cur...
My current setup is:2851 Gateway with a 4 fxo card installedPBX phone line plugged into port 0/0/0CCM v 5.1I can call any internal office number and any off site local or long distance number from my IP Phone through the PBX with no problems but when...
We have a 3560G switch that we are using on a ONS backbone. We have the last 16 ports running Trunked mode up to a 454 SONET ONS. These ports are currently connected to ML 1000 cards that control the IP portion of the SONET. I need to setup the spann...
Does anyone know if the new 8.0 release will support a many private addresses to one public address. We have had alot of problems with an older release not supporting this at all. We have clients where we are that access Win and Nortel VPN servers at...
I am trying to configure MGCP so that I can use the fxo's on the VG to allow IP phone users access to long distance and on site extensions through CCM. This would be a 6 to get long distance and the extension to dial on site. I have configured the Ga...
WOW fast responeses this is supposed to be a forum where we can get answers? What a waste of time. You should just shut this down now. Watch I bet this gets answered or deleted
Thats my problem that I am trying to figure out. Lets say that I have port 34 going to port 1 on a ML Card and port 35 on port 1 on another ML card. Basically the other side of the ring coming back in. Now when I do a sh spanning-tree inter giga 0/34...
Below are my configs of the VG. I plugged a phone line into port 0 and if I hit a 9 I get a dial tone but it wont dial anything after. busy after digits are dialed. Do I need to configure a destination-pattern on the dial-peer voice pots? Alos what d...
