Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have had a site that has worked with no problem until today. I am getting Phase 1 with no problem and have multiple IPSEC tunnels established. The problem I am having is with the remote site getting to a specific host. I am getting the following...
Ok here is my scenario. We have a remote router that has a static nat that points to a server in datacenter1. We now have datacenter2 with a clone server. Basically I am trying to get CSS functionality out of our 1841 except I just want Active/Pas...
I am beginning to run out of address spaces and I am looking at getting another range. I would like to create sub-interfaces but I am running into one problem. When I move the interface "outside" interface to one of the subinterfaces anything appli...
I am trying to enter the following command on some of our remote vendor sites. Some of the sites allow me to enter the stub redistribute command and some will not. I have varying IOS versions on these routers but all of them are higher than the 12....
Has anyone performed a 7.2.4 upgrade to 8.0.4 with zero downtime? Here is the recommended upgrade paths from cisco about a major upgrade. You can upgrade from the last minor release of the previous version to the next major release. For example, yo...
Not sure if you are having the same issue but here is a whole forum that was dedicated to a SQLNet problem in 8.0(4).http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Firewalling&topicID=.ee6e1fa&CommCmd=MB%3Fcmd%3Dpass...
Nope. Just trying to issue the commands I posted. No eigrp stub receive-only statement. Below is the options I see when adding the statement.When option is not available.eigrp stub ? connected Do advertise connected routes receive-only Set ...
